Flooring contractor in San Fernando, CA - floors built on a tested slab
Artisan Epoxy Floors of West Hollywood coats, polishes and resurfaces concrete floors in San Fernando, CA, from garage and basement slabs to shop and storefront floors, testing and preparing the slab before any coating goes down.
- Epoxy Floor Coatings
- Commercial & Industrial Epoxy Floor Coatings
- Garage Floor Coatings
- Polyaspartic Floor Coatings
- Metallic Epoxy Flooring
- Urethane Cement Flooring
- Polished Concrete Flooring
- Stained Concrete Flooring
- Terrazzo Flooring
- Basement Flooring
- Concrete Grinding & Surface Preparation
- Concrete Sealing
- Concrete Resurfacing & Overlays
- Self-Leveling Concrete & Overlays
- Pool Deck Coatings & Resurfacing
- Concrete Floor Stripping & Removal
- Licensed and insured.
- Free estimates at your property.
- Expect a reply within 1 business day.
San Fernando floors we're usually called about
San Fernando is a compact city in the northeast San Fernando Valley, with blocks of older single-story houses, many with detached garages, and small shops and restaurants along its commercial streets. The garage is usually the floor we're asked about, and on these houses it often has decades of oil, patching and old paint on it. We come up from West Hollywood for this work, the same way we do in Burbank and as far south as View Park-Windsor Hills. On any of these jobs, the price moves mostly with how much old material has to come off and how much repair the slab needs, and the schedule turns on that prep, the coating's cure time and whether a permit is involved, so your own figures come from the estimate at your floor.
The slab sets the plan. An older Valley slab may sit right on the soil with no moisture barrier and a long history on top of it, so I test it and decide how deep we grind before we talk about colors or finishes.
Why San Fernando slabs need careful prep
- Older garage slabs here usually carry years of oil, old paint and patching, and a coating only holds as well as the bare concrete under it.
- Valley summers run hot, and a hot slab shortens the time a coating stays workable, so we plan the coat for the cooler part of the day.
- Older slabs can push moisture up from the ground, which lifts coatings from below, so we test before choosing a system instead of after a failure.
Floor and concrete work we do in San Fernando
Epoxy Floor Coatings
A good fit for a San Fernando garage, laundry room or workshop floor that's dull and stained, once we've ground it down to clean, open concrete.
Commercial & Industrial Epoxy Floor Coatings
For shops, restaurants and small warehouses that need a hard-wearing floor and can't afford to close twice, so we plan the prep and cure around your hours.
Garage Floor Coatings
The call we get most here, a detached garage with oil spots and old paint that we strip and grind before a flake or solid coat goes down.
Polyaspartic Floor Coatings
When you want the garage back quickly, a polyaspartic topcoat cures faster than standard epoxy and holds up well to the sun at an open garage door.
Metallic Epoxy Flooring
For a living space, studio or shop floor where you want a poured, marbled look, laid over a slab we've leveled so the finish doesn't show every dip.
Urethane Cement Flooring
For restaurant kitchens and food prep areas that see hot water, grease and daily washdowns, where a thinner coating would soften or let go.
Polished Concrete Flooring
When a storefront, studio or converted garage sits on a sound slab, we grind and polish the concrete itself, so there's no coating to wear through.
Stained Concrete Flooring
Color that soaks into a patio or interior slab rather than sitting on top, tried on a small spot first because older concrete takes stain unevenly.
Terrazzo Flooring
For a lobby, entry or shop floor meant to last decades, or to bring back older terrazzo that's been hidden under carpet or tile for years.
Basement Flooring
Basements are less common here, so this usually means a below-grade room or cellar where we test for moisture first and choose a coating that tolerates it.
Concrete Grinding & Surface Preparation
The first step on almost every San Fernando job, taking off old paint, sealer and oil-soaked concrete so the new floor bonds to clean, open slab.
Concrete Sealing
For driveways, patios and garage floors you'd rather keep bare, a penetrating sealer helps keep oil and water from soaking into the concrete.
Concrete Resurfacing & Overlays
When a patio, walkway or driveway is worn or patched in three colors but still solid underneath, an overlay gives it a new surface without tearing it out.
Self-Leveling Concrete & Overlays
For uneven floors in older buildings and garage conversions, a self-leveling layer flattens the slab so tile, plank or a coating lies flat.
Pool Deck Coatings & Resurfacing
For backyard pool decks that are cracked, faded or too hot underfoot in the Valley sun, we repair the concrete and coat it for grip.
Concrete Floor Stripping & Removal
When old epoxy, paint or glued-down flooring has to come up first, we strip it to bare concrete so the next floor isn't built on a failure.
- Request an estimate
Get a free on-site floor estimate in San Fernando
We reply to every call and message within one business day to set a time for me to come out to your San Fernando property. I'll look at the floor, test the slab and walk you through the plan and the price, with no obligation to go ahead. If you do, our own crew does the work.
(213) 329-1493Flooring questions from San Fernando homeowners
Who issues building permits for a floor or concrete job in San Fernando?
The city's Building and Safety Division issues building permits for work inside San Fernando city limits, reviews the plans and inspects permitted projects. The city prefers applications through its Online Permit Counter, offers in-person help Monday through Thursday from 8:30 am to 12:30 pm, and says it can't promise a permit right away. We check whether your job needs a permit during the estimate, and when it does, we handle the application and the city's paperwork for you.
Does a flooring contractor from outside San Fernando need a city business license?
Yes, the city requires anyone doing business in San Fernando to hold a valid city business license, and a contractor based elsewhere has to get one before starting work inside city limits. That holds even when another city licenses them, and the city says holders of a California contractor's license need one too. It's a fair question to ask any contractor you're comparing.
When does a flooring job in California need a licensed contractor?
Under the Contractors State License Board's rules, a contractor license applies when the job needs a building permit, uses any additional workers, or costs $1,000 or more in labor and materials together. A bigger job can't be split into pieces under $1,000 to stay below that line. We're licensed and insured.
How much does an epoxy garage floor cost in San Fernando?
The price depends mostly on the condition and size of your slab, not the coating, so we give you a figure after I've seen the floor. Old paint or sealer that has to come off, oil soaked deep into the concrete, cracks to repair and moisture that calls for a different primer all add work, while a sound bare slab keeps it down. The system you choose matters too, since a solid color takes less material and labor than a full flake broadcast or a metallic finish.
How long does a garage floor coating take in San Fernando?
Most of the schedule goes to prep and cure time rather than laying the coating, so the length of the job depends on what your slab needs and the product you pick. A floor that needs old coating stripped or cracks repaired takes longer, and you'll keep cars off it until the coating has cured, which takes longer for standard epoxy than for polyaspartic. If the job needs a permit, the city's review adds time before we start.
What causes epoxy to peel off a garage floor?
Peeling usually comes from a step skipped before the coating went down, most often a slab that wasn't ground clean or one pushing moisture up from below. Epoxy rolled over oil, old paint or a smooth sealed surface has nothing to grip, and on the older slabs we see in San Fernando, all three are common. That's why we test the slab and grind it to open concrete first, and if your floor is already peeling, we strip it before laying anything new.
Call about your San Fernando floor
We answer until 11 PM every day of the week, so call (213) 329-1493 after work or send your project details whenever it suits you.